!
!
Velleman
5,410,329,680,848.00
5-7 Days
VMA421
Weight: kg

WATER PUMP

Create Your own plant watering system or build a automatic aquarium refill system by using Your arduino and this powerfull small water pump
Velleman
5,410,329,680,855.00
5-7 Days
VMA422
Weight: kg

WATER VALVE

12V Water Valve
Velleman
5,410,329,680,879.00
5-7 Days
VMA424
Weight: kg

2-CHANNEL POWER MODULE FOR BREADBOARDS 3.3V/5V

This breadboard 3.3V / 5V power supply module fits the power rails on most breadboards. It also features a mini USB power port to supply power to external devices.
Velleman
5,410,329,680,886.00
5-7 Days
VMA425
Weight: kg

4-DIGIT DISPLAY WITH DRIVER MODULE (TM1637 DRIVER)

With this 4 digit Seven segment display module, you can easily add a 4 number LED readout to your projects. Useful for making a clock, timer, temperature readout, etc.
Velleman
5,410,329,680,909.00
5-7 Days
VMA427
Weight: kg

40 PINS 15 cm MALE TO MALE JUMPER WIRE (FLAT CABLE)

This flat cable can easily be stripped apart into a single (or multiple) jumper wires.
Velleman
5,410,329,680,916.00
5-7 Days
VMA428
Weight: kg

40 PINS 15 cm MALE TO FEMALE JUMPER WIRE (FLAT CABLE)

This flat cable can easily be stripped apart into a single (or multiple) jumper wires.
Velleman
5,410,329,680,923.00
5-7 Days
VMA429
Weight: kg

40 PINS 15 cm FEMALE TO FEMALE JUMPER WIRE (FLAT CABLE)

This flat cable can easily be stripped apart into a single (or multiple) jumper wires.
Velleman
5410329680930
5-7 Days
VMA430
Weight: kg

GPS MODULE U-BLOX NEO-7M FOR ARDUINO®

The NEO-7 series of standalone GNSS modules is built on the exceptional performance of the u-blox 7 GNSS (GPS, GLONASS, QZSS and SBAS) engine. The NEO-7 series delivers high sensitivity and minimal acquisition times in the industry proven NEO form factor.
Velleman
5,410,329,680,947.00
5-7 Days
VMA431
Weight: kg

ELECTROMAGNET MODULE

High Quality Electric lifting magnet
Velleman
5,410,329,680,954.00
5-7 Days
VMA432
Weight: kg

DMX512 MODULE

This Arduino add-allows you to use the Arduino as a DMX master device (transmitter). This board is a simple circuit based around a driver chip (MAX-485 or SN 75176). With XLR 3 pin male DMX output connector. Pin1 = Signal Common, Pin2 = Data-, Pin3 = Data+ The board converts the Arduino signal voltage according to DMX (RS485). Impedance is 100 Ohm.